SD card SPI led remote controller adopts the sd controller chip, it is used for controlling a variety of lamp
whose source of light is LED. For instance, point source of light, led bulb remote，flexible light strip, wall
washer lamp, glass curtain wall light and so on. Using wireless led remote controller and button control,it
have choose pattern files, adjust rate of change, choose output IC, set the date, timing the festival,
power-down storage and switch function. When system power on, it will search all the "*. LED" files in the
SD card ascending sort by file name, read and play the last saved file mode. Users can through buttons to
select the change pattern.After select all the files,then press the file add button, it is cyclic display pattern
file. It has many advantages such as wiring flexible, easy wiring, simple to use and so on. According to the
actual need of customers, it can realize four channels and jumpy changing, gradual changing, strobo flash
and other effects of change. User can also edit the data flies through the incidental pattern editing
software(Led Editor v1.0), many kinds of change patterns, easy to use, the specific method of editing
software, please check the software instruction.
Working temperature: -20-60℃
Power supply voltage: DC5V-DC24V
Remote control distance: ＞25m
External dimension: 240 * 145 * 39 mm
Packing size: 315 * 175 * 75 mm
Net weight: 923g
Gross weight: 1294g
Power consumption: < 0.5W
Frame frequency: max 25 frames per second
Support chip: common single line, double line IC on the market
Output: 4 channel
Control points: max 1024 each channel
Grey: 32 magnitude
Maximum number of documents pattern: 64
|LED strip Model
Remote control button instruction
: Model add : Mode minus
: Speed minus : On/off key : Speed add
For the convenience of operation, it can adjust the mode, speed, on/off directly on remote control,and enter into
Panel button instruction
Menukey: return to the previous menu
Enter key: enter the next menu
Up key: turn on the menu or add
Down key: turn down the menu or minus
SPI signal output interface: GND is common ground, DATA is data interface, CLK is clock interface, in total 4 channels.
Power supply interface: input DC5-24V.
SD card slot
Power: power supply indicator light, it will bright when power on.
Signal: button and remote control indicator light, it will flicker when there have button or remote control operate.
Status: working state indicator light, it will flicker when there have SPI output, flicker frequency relate to output speed.
Single wire IC, signal wire only connect data corresponded terminal, as shown in figure.
Double wire IC, clock line and data line connect corresponding terminal, as shown in figure.
1. Connect the load wire at first, following by the power wire;
Please ensure short circuit can not occur between connecting wire before you turn on the power;
2. Power supply voltage range is DC5~24V, more than voltage range maybe burn out the controller.
3. Reset operation can be performed when pluging SD card.
4. Make sure SD card is formatted (FAT32) before use.
There are currently no product reviews.